Best Of The Best Info About How To Build An Outboard Stand
So we built one, super sturdy to support up to 375lbs.
How to build an outboard stand. Start by cutting four pieces of 2×4: The height, 4×4 3′ (will change once i decide it) notched 1″ into the bottom runners. Dropping the lower unit and changing out the impeller, on the other hand, can get tricky!
In this video i show you how to build an outboard motor stand. The bottom runners will be 4×4 3′, 2 feet behind and 1 feet in front. The 36” pieces will form the base of the motor stand.
Especially if you have nowhere to work on the lower unit. Two pieces that are 36” long, and two pieces that are 24” long. Diy outboard motor stand pictures and plans.
I put in a single screw on each side, so that i could tilt the stand back a bit, reflecting the slope of a transom. Fasten the board to the legs and put the. According to the small or large outboard motor stand plans, begin by splitting four pieces of 24 into two 36″ long pieces and two 24″ long slabs of wood.
This homemade outboard motor stand is built from scrap wood i managed to find around our home. I innertubed the clamp over the push handle cuz i was in a. Take the two 36” base.
First attempt at mounting the board mark where the bolt holes should be and drill them slightly over sized so you have some wiggle room. The 36″ sections will be used to. How to make a lower unit stand!